TBS partnered with Zeez to make this awesome whoop AIO. Introducing the the TBS Podracer AIO, the board is designed to cater for TBS Pro32 Nano VTX and TBS Crossfire / Tracer Nano RX with direct pin-header installation. The result is a clean, compact and lightweight core for your build..
The FC is equipped with F4+MPU6000 and the ESC is capable of True 30A current running BLHeli32. This board is versitle enough to run on your cinewhoop, 4/5" racer like the podracer and longrange cruiser like the TBS Aureo. 
 
FC SIDE
Mounting holes: 25.5×25.5 mm / M2 holes
Crossfire/Tracer RX CH1&2 > Uart 2  /  Pro32 Nano VTX > Uart 1 / Uart 1(RX) - unavailable.
Up to 6S input
5V BEC up to 1.2A continuous
STM32F411 MCU (Support BetaFlight, EmuFlight)
MPU6000 Gyro/ACC
OSD chip Onboard (AT7456E)
2 available UART
LC Filter for 5V VTX and Camera
Direct solder connection for TBS Nano RX and TBS Unify Pro32 Nano
Support programmable LED like WS2812 etc
Built-in current sensor
 
ESC SIDE
Signal support: PWM, Oneshot125, Oneshot42, Multishot, Dshot150, Dshot300, Dshot600
Input voltage: 2S-6S Lipo
Continuous current: 30A
Peak current: 35A
ESC firmware: BLHELI 32
PWM Frequency Range: 24KHz up to 96KHz